Mortars for floor levelling
Before the tiles are set, the floor has to be smoothed and levelled.
Nivosol Flex 10
Thin-layer surfacer for interior and exterior floors
Field of Application
For layer thickness between 1mm and 10 mm for surfacing, levelling and smoothing substrates ready for tiles or slabs etc. to be laid on top. High compressive strength, suitable for underfloor heating and for loads applied by chairs on casters. Can be used in dry areas, for interior applications.
Characteristics
Strasser’plan DBS 10 is a self-levelling, polymermodified, water-resistant, cementitious, low-shrinkage surfacer for interior and exterior floors. This product sets rapidly and can be walked on after only a short while.
Consumption
1.7 kg premixed dry mortar per mm/m²
Technical data
Colour:
Cement grey
Application temperature:
+5 °C to +25 °C
Layer thickness:
1 to 10 mm
Usable life of mix:
± 30 minutes
Can be walked on:
After ± 2 to 3 hours, depending on the temperature
Ready to be tiled etc.:
After ± 1 day
Compressive strength:
After 1 day ± 18 N/mm²
Compressive strength:
After 28 days ± 30 N/mm²
Flexural strength:
After 1 day ± 4 N/mm²
Flexural strength:
After 28 days ± 7 N/mm²
Strasser’plan DBS 10
Cement composite level screed with flowable properties for layers from 20 to 40 mm thick
Field of Application
Suitable for a layer thickness of 20-40 mm. Strasser’plan DBS 40 can be used as a composite screed, floor levelling compound and heating screed, especially in redevelopment and renovation areas. Can also be used for quick-drying and instantly workable cement screeds and is suitable for use with office chairs.
Characteristics
Strasser’plan DBS 40 is a synthetically enhanced, self-flowing, self-levelling, pumpable, quickly hardening, shrink-resistant, waterproof and very pressure-resistant composite levelling screed with flowable properties on a cement base.
Consumption
1.7 kg of dry mortar per mm/m²
Technical data
Colour:
cement grey
Processing temperature:
+5°C to +25°C
Layer thickness:
2 to 40 mm
Processing time:
approx. 60 minutes
Walkover time:
approx. after 3 hours, depending on the temperature
Ready to be covered:
after approx. 3 days, depending on the temperature
Ready to be covered:
check remaining moist content with CM-equipment
Compressive strength:
after 1 day approx. 12 N/mm²
Compressive strength:
after 28 days approx. 35 N/mm²
Flexural tensile strength:
after 1 day approx. 4 N/mm²
Flexural tensile strength:
after 28 days approx. 9 N/mm²
